Need Help Tonight - Bolt Stick?

[gonefishin]

HELPPPPPPPPP!!!!!

I am playing in my first turney in the morning and I was working on my RT tonight. Just replaced sear assembly and bolt (the old ones were pretty torn up).

When I gassed the gun up, I was able to pull the trigger once and it fired fine. After that, I had pressure on the trigger, but no action.

Things to note:

1) I was down to about 500 psi in my tank and I cannot get more air until the AM.
2) No apparent air leaks that could be heard
3) Tried pushing bolt back (no barrel on) but would not move
4) Have AGD 2x Intelleframe
5) Trigger rod on new sear from AGD is longer than one I took of out the marker. In fact, when it is gassed up, there is no space between the trigger and the rod. I do not have anything at home to get an accurate measurement off the two rods.


Any suggestions???? Help.

Other than that, the new flatline and warp look awesome on the RT!!

[BlackVCG]

First of all, adjust your trigger rod so that there is a small gap inbetween it and the back of the trigger when gassed up. Then get your tank fully filled, set the output to 700psi and try it out. If you still have bolt stick, switch to a spacer one size longer. That should get the gun working just fine.

[gonefishin]

Thanks BlackVCG!

I wasn't sure if I should adjust the trigger rod or not. Everyone said is should be the correct lenght straight from AGD. Oh well....

I will give this a shot when I get my take filled this AM. If that does not work, hope someone has a different marker I can borrow for the turney.

Thanks again.