Some Emag problems

[gimp]

I was playing with my E-Mag this sunday, and I had some problems. I chopped a few balls, but that was my fault. shooting to fast, and forgeting to turn on the rev (Doh!). At one point though, the gun just stopped. It wouldnt shoot in manual, or electric. This is what I did. I turned off the powerfeed, and took off the barrel. Then I tried to fire it in electric mode, and it wouldnt fire. After like, 30 seconds of switching back and forth between manual and electric I got it to shoot in manuel. I put the barrel back on, turned on the powerfeed, tried electric again, it wouldnt work. I tried electric again probably 20 seconds later and it did work. Then the game was over

I dont know what caused this, but I have some ideas. First of all, it wasn't a piece of a ball that got stuck or anything.

I think it may have something to do with my safety. I lost the little ball that keeps the safety from just sliding freely. So I just taped the safety into the fire position. I dont think this is what effected it, because I could shoot in manual, but I thought I'd add it.

The other thing that might be the cause of the problem is the rubber bumper between the bolt and the valve. Mine is getting kind of old. The hole in the middle of it is a little bit bigger than the powertube, so it moves areound just a little. I dont think that would make the gun stop firing though.

I have no clue what was happening. It is Version 1.35 too, if that will help.

[AGD]

Hi Gimp,

Not really enough info here to figure out your problem. Off hand it sounds like bolt stick. You might need to go to a longer spacer.

AGD

[gimp]

Ok, I can use the powertube spacers for my regular mag right? I dont really have any more info to give. It's only happened once, so I'm not worried.

[BlackVCG]

All PT spacers are interchangeable with all AGD guns.