Suggestions on Trigger job for 2x Benchmark frame

[Elite-X]

anyone got any suggestions on doing a trigger job for my 2x benchmark trigger frame. Any ideas about shortening the trigger pull with the sear or anything. letme know

[Bartleby]

you don't want to mess with the sear or trigger rod. things like that can make huge problems. the best thing you can do is get a better trigger. benchmarks are not the best things for mags....actually they're quite horrible. if you want a better trigger pull either get an intelli-frame or retro valve. Maybe even both

[Elite-X]

i was hoping there might be a way to extend the trigger rod to reduce the pull to make the mag shoot but i cant figure anything out.

[Bartleby]

i'm sorry, actually you could unscrew the trigger rod untill it comes within about 1/8 of an inch when the gun is gased up. that would take a bit of the slop away from it.