Barrel

[Kyleb44]

Ok i bought a new 68 automag classic stardard feed from paintball gear.com and they bunddle it with a barrel(not sure what kind) and every time i put the barrel in it gets stuck and wont come out i got it out the first time by taking the whole gun apart and then tired to put it back in and it is gettting stuck

[rikkter]

on the barrels there are this line with a 90 degreeturn. there should be two of them.. one of them goes to the left, and the other to the right, but some newer barrles only have ONE with two 90's going in both directions.

anyways, theres a pin on the bottom on in the inside where you pt the barrel. line that up with the line part on the barrel. push it in all the way, then twist it to either the left or right so the balls will be able to feed.
to take it OUT, simply twist it the oppsite way, then pull out. it should come out, if not, grease the orings on the barrel a little so it won't stick

[kazvall]

Another problem that you could be having is that if the nubbin and the oring stick to far out from the groves in the barrel, the barrel might not have enough room to slide into the tube. If you notice that when you take it out your oring is stretched and rolling backwords on the barrel, all you need the do is shave down where the oring and the plastic meet, not all the way though, and it should work. Also use some grease.

Hope you made sense of that ^_^