whats the best way to clean my revy w/o damaging the electrical components?
-
We are all like raindrops falling from the sky, eventually landing on this sandy star and drying up from the heat of the sun. Even if protected by a huge umbrella, we never know what tomorrow may bring. Someday we will be blown by the wind and absorbed into the sandy earth. -Trigun -
it is actually quite simple to just unscrew everything. on the intelliframe instruction page, it shows u the precise way to do itArggggh
HATE HATE HATE HATE HATE HATE HATE HATE HATE
cold as ice -
Are you chunking balls inside your Revvy? If so, you've got bigger problems. If you've got a lot of paint inside, then you definitely need to take it apart. Otherwise, you should just be able to stick a lightly damp cloth inside and twist it around. Then use a dry cloth to clean up any residual moisture. You should be good to go after that.
"Otaeri wa doko desu ka?"
------------
--Duct tape is like the Force. It has a light side, a dark side, and it holds the universe together.
------------
Think you're ready, Grasshopper?
www.ohioshaolin.comComment
-
remove all the screws, lift out the board, servo, and sensor. rinse the two shells under a faucet. JUST MAKE SURE YOU DONT GET ANY OF THE ELECTRICAL COMPONENTS WET!Comment
-
you can just squirt water into it and then dry it out
just as long as u dont get too much water in it
Comment
Comment