warp runs after 12v mod

[tl1000s]

I just finished converting my warp to 12v, plus I put in an on/off switch (put in an on light too, but had problems with that), and now it runs all the time when I switch it on. Is this a sensitity adjustment problem? and how do I adjust for that?

[virus]

take the black cover and lok for the blue pot.... turn it clockweise to turn it up and counter-clockwise to turn it down

[CleenSweep]

You need to put a buffer in

I had the same problem with mine when I switched it to 12v and wanted to run it on the sensor. It just keeps running when you turn it on, so here is what you must do.

You must put in a 10 microfared capacitor. Connect it on the wires going to the board.

What it does:
Even when using a 12v regulator, you will still get like 12.1 or 12.2-12.4volts. The capacitor will buffer the current and let it drop just enough (11.8 or 11.9v) for the sensor to adjust and shut the feed off. It may seem complicated but it's really quit simple. I've had mine on for quite some time now and it works like a dream. No problems at all.

[tl1000s]

cap size

does it matter what size cap you use? you mentioned 10uF, and AGDrob mentions 100uF. I always thought the cap was to eliminate radio interference from the motor that would louse up an e-trigger.

[FrAuStY]

Theres apicture of a voltage filter for your regulator on http://www.robagd.com/revy-hack/