Connecting Intelliframe to Warp or Revy or Both

[Bigdaddy]

I run a warp and revy. I have my Intelli frame running to my warp feed presently. Is it possible to hook up the revy also. I know the wires could be hooked up but, will the warp and revy work together properly if they are both ran from the switch from the Intelli frame?

[keiphers]

I did this, and yes it works correctly. Its actually really cool, but don't put in the intellifeed wires until you have paint in the Revvie. The Revvie somehow even overides the intellifeed. When a ball isn't in the infared eye, it spins (as normal) but also makes the Warp spin (very cool). Otherwise, it works like normal Intellifeed. I haven't chopped a ball since I did this.

[Bigdaddy]

Thanks for responding, I'm going to hook it up today and see how it works.

[Bigdaddy]

The revy takes control and seems to overide the warp and makes it spin even if I dont push on the switch. Any one help me out with this? Its all installed correctly I triple checked everything. The problem is the revy spins on its own and then the warp spins continuosly after the first push on the switch. I put paint in the revy first then connected the connections for the warp and revy. Anyone help me out with this one?

[keiphers]

Hmmm... since we have the same setup, here's how mine works:
1. load paint in the hopper (or cover infared eye with finger) and use button to feed it threw warp (if using paint)
2. put in the hopper intellifeed plug and turn on hopper (shouldn't spin), then test intellifeed by pressing trigger (should spin) then release
3. put in Warp intellifeed plug (shouldn't spin), then test by pressing trigger (everything should spin)

After that, nothing should be spinning, unless you pull the trigger/press the microswitch. With the Warp plug in, it will spin, unless the infared eye on the hopper is telling it not to. I'm not sure how it works, but it does. I don't know about the Warp continuously spinning after pushing the button.

[Bigdaddy]

Its working fine, I fired some paint. It works like it should. When the revy is empty the warp spins, thats the only downfall I see. The warp will have to be shut off by "pulling the plug". Thanks Keiphers for taking the time to post. I'm going to see if can fix this very small problem.

[keiphers]

No problem. But, if you figure out how to stop that little problem, post on here (I'd like to know too).

[Bigdaddy]

Instead of pulling the plug you could install a switch on the wires that run to the warp. A switch like the one the revy has. Just a thought.