Pump Kit Body

[SqueegeeKid]

I just bought a body i plan on using on my soon to be assembled PumpMag. I just noticed there is no slot milled into the bottom of the body to accomodate the pumparm.
I'm wondering how i might go about getting it made.

Is it easy to do myself?
Can i send it to AGD to get done? If so at what cost?

I'm going to call AGD Monday, just wondering if i can get an answer in the mean time.

[BTAutoMag]

i have a body milled for a pump. ita a HR polished body and ill give it to ya for a HR polished body or a WL polished body. the body is a automag body but ill take any kind except old school RT bodies.

[xmetal2001]

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=295&CATID=5

That body has the pump arm slot. I dont know if you would like that body though, its "unique".

[SqueegeeKid]

Those things are Fugly!
Nah, i was hoping to just hack up the current body i have, or perhaps swap it for one one exactly like it.

polished powerfeed hopper left.

I already have a body with the pump slot in it, but its on my normal Mag and its hopper right attached to my Warp. I'll switch em around if i have to, it's just gonna be a pain. Although it'd be easier than swapping with someone else, or sending it off to get milled.