E-Mag On-Off pin

[Kevmag]

I was cleaning my E-Mag the other day and noticed the on-off pin is very short. It doesn't stick up past the on-off bottom. It looks like it is not even there (I'm sure it's just recessed past the bottom). Is this a problem or potential problem. The pin on my Retro AM sticks out past the bottom quite a bit.

BTW - the EMag shoots fine, so I rather not fool around unless I hear otherwise.

Kevin

[Potatoboy]

The on/off pin on the Emag is supposed to be that short. The one on the Retro and RTPro are noticably longer.

[Kevmag]

Thanks! That's what I was hoping you'd say.

[BlackVCG]

If you have calipers it should measure to be .712" if you have a brass top piece, or .725" if you have an aluminum on/off top.