Service Mode on the Hyperframe?

[Blaze16016]

According to Centerflag there is a Service mode on the Hyperframe which will allow you to change the amount of energy it takes the frame to release the bolt. But I can't figure out how to get into this mode and the Centerflag instructions do tell you either. HELP!!

[2UnREal]

Call them up and ask them.

[Chris]

I believe the Mode button is the power button, so going from there...

Start with the frame off
Press the power button and hold it
At the same time, or just slightly after pressing the power buttton, press your other button.
You should see something on the screen that says "S7" You can adjust from here as you would in any other mode, the higher the number, the more power is used to activate the solenoid.

Sorry for being so vague, I just sold my hyperframe, and dont have one in front of me. Hopefully this helps though.

-Chris