Need help with my warp

[paintballrulzs]

Ok i have been talking to my teamates and they are trying to convince me to keep the warp feed. When i played saturday i chopped horribly with the warp feed. I mean i chopped atleast 1 in 10 balls. The battery was brand new and the dwells and all that was set perfect. I am using a hyperframe and it is on a hopper right minimag body. I took it off for the day and didnt chop a single ball, but my performance suffered. The next day we had our tournament. We ended up taking first, rolling every single team and maxing out on every game but 2 (12 games total). This tournament was all without my warp feed on. I was wondering what could possibly cause it to chop like that with the warp, and without the warp not chop a ball?

[jah871]

make sure there are no really tight bends in the hose and make sure its connected securly to the body. when i first got my warp it caused me to chop a lot because i had to use the 90* adapter but once i drilled my hopper and got a h/r body it works flawless. also make sure the parabolic plug is adjusted right too.

[hitech]

Try reading this:

http://www.automags.org/forums/showthread.php?s=&threadid=12140

[paintballrulzs]

i run it from the bottom, where the plug usually goes.

[than205]

Hitech is right, you want to be certain about that ball stack.
Have you:
1. replaced those screws that were holding your warp to your frame?
2. gotten that grit out from under your sensor?
3. looked into getting the updated sensor?
4. (this is the most important) talked to NPP about hooking up the Hyperframe to Intellifeed?

http://www.automags.org/forums/showthread.php?s=&threadid=40841

Intellifeeding is the way to go!

[paintballrulzs]

I did all of those you said except the last. I read on that thread that he never got it successful. I would love to use a warp because i stay so tight with it, but it isn't looking good.

[than205]

NPP said - "Hyper Frame to Warp, fires with intellifeed without problems. "

Talk to him. I'm sure he will let you know what he did.

[FrAuStY]

Just curious...but I had problems with my warp chopping one game. I found out..it was my barrel. For some reason..under the force of the warp..the barrel would untwist just enough for half a paintball to get in it. I later just wiped the oil off the orings and it stayed where I put it. Anyway..just a suggestion. I hate seeing people having problems with warps. They are definately one of the best investments I made. Anyway...make sure you have the correct ballstack... also double check your feed plug. I used a small flashlight and adjusted the feed plug until the inside odge of the parabola was flush with the outside of the feed hole in the barrel/body. No problems at all after that..even with my barrel untwisting a lil. Good luck

[paintballrulzs]

thanks guys. Than i was thinking of something else. Sorry