Micro Emag +lvl 10 problem
Installed lvl10 kit on my emag and every thing seems ok untill I tried to fire it in mechanical mode. THe sear does not fully releasing the bolt.
-
If it wasn't for bad luck. I'd have no luck at all. -
Does your trigger pull all the way to the back of the frame in M-Mode? If so, put the gun in E-Mode and pull the trigger back. How much space is there inbetween the tip of the trigger rod and the back of the trigger? I'll bet the rod is too short and you're not able to drop the sear far enough. There should be about a 1/16" gap inbetween the trigger and the trigger rod when the gun is in E-Mode and pulled back as far as possible.
Comment