warp feed problem

[bones]

I am having a serious problem with my warpfeed feeding balls when I pull the trigger. I just replaced the circuit board, so that is bran new. When I tested it, the conveyor would not spin when i shot, hence, no balls in the barrel. I checked all the wiring to make sure that it was all connected and all was good. When I hit the white loader button, it works, but not when I shoot. Please Help. I have a scenario game this weekend and would like to use the system.
Shawn

[Polishpickles451]

your sensitivity is too low.
open the circuit board black cover and find the blue dial, rotate is clockwise until the warp starts spinning, then back it off so it stops. Your warp is on the lowest sensitivity and works great on my gun, feeds only when it should.
good luck

[bones]

I figured out the problem. When I received the new circut board, there were no jumpers put in, so I took off the old jumpers from the other board and now it works wonderfully. Thanks for you help. As for that blue dial, I was unaware of that, so now I know. Thank you again for your input.