Alright If You Look On The Trigger, The Little Silver Piston Thingy Behind The Trigger, I took my whole gun apart to see if i could screw the little piston thingy in more to shorten the trigger but i don't know if it will work
-
"Hey its the new transparent aluminum gun!! Must be light because you cant see it!" ------AGD -
Don't mess with it!
Everything I've read says not to mess with the sear's trigger rod. I tried to do the same thing you want to do and it made my 'mag short stroke on every shot. I quickly set it back to the way it was. I think the default adjustment for the rod is to have a 1/16" gap between the back of the trigger and the rod.
Resist the temptation, man! -
Oh Ok Thanks Man I Appreciate it,
"Hey its the new transparent aluminum gun!! Must be light because you cant see it!" ------AGDComment
-
I have one more problem I was Putting My Valve back in and my bolt pell off and when i turn my valve bolt side down the bolt falls off and when i finally put it back together there is a Small Square Shaped Nut Left Over
"Hey its the new transparent aluminum gun!! Must be light because you cant see it!" ------AGDComment
-
You can adjust it a very small amount but you might have a problem taking the valve out.Ya Man, thats PCP
Comment
-
Trigger Rod Ajustment
I say do mess with the trigger rod, it wasn't designed to be ajusted. AGD did a lot of work on it already, and it shouldn't be touched. For better performance upgrade to a ReTro Valve and/or Intelliframe. I got both and I'm glad I did. One thing though, if you have a Minimag and want an intelliframe you will probably have to change your foregrip or expansion chanber because it won't fit.
Intellifed Mini RT (Upgrading to Level 10)
Smart Parts barrels
Comment
Comment