Warp and Piranha question

[Albino]

Does anyone else have a Warp on a Piranha? I have a P/F (powerfeed) STS, and I run the warp tube directly into the bottom of the P/F tube (I'm left-handed). Anyway, my problem is that the Warp double-feeds about 1 out of every 20 shots. What's worse is that about once every 50 shots it will push the first ball forward, but not far enough for the second ball to totally chamber. So, it chops the second one. The Warp manual mentions that you need a strong enough ball detent to keep this from happening. Where can I get one? Or, is there another way to fix this problem?

Thanks,
Albino

[Load SM5]

Check to make sure the nubbin is'nt worn down and allowing double feeding. You also may want to play with the warp jumpers a bit. It sounds like the warp is spinning a little too much and forcing the paint in. Check with the online manual in the Airgun Store (link on top of page)if you don't know how to play with the settings.

[Albino]

I tried shortening the dwell on the Warp. I'm going to play with it on Saturday, and see if that helps. I fired about 50 shots through it and it didn't double-feed, but it skipped two shots. Does that mean the dwell is too short now?

Albino

[virus]

just turn the sensitivity up a hair now and you should be good.... ie the little blue pot with the white top, on the board....

and welcome to AO...

[Albino]

Well, I can have the sensitivity all the way down, and it'll still spin, even if I just cock it and fire without air. Does that affect your satement?

Thanks for the welcome (even if I don't have a 'Mag)

Albino