E-Mag/intellifeed question

[ben_JD]

I currently use an Automag with AGD Intelliframe for use with my Warpfeed/HALO combo. I don't use the vibration sensor at all, I just have the Warpfeed hooked up to the Intelliframe and it works like a charm. I have a new E-mag on order and want to do the same thing, but have a question as to the way the intellifeed works when the E-Mag is in "Manual" mode (not hybrid).

Does the board still send out the signal to the Warp when it is in Manual mode?

[BlackVCG]

No.

Only when the board has power to it, by pulling the yellow pin, will the interlink cable send a signal to the Warp. If you plan on using Manual Mode, you'll need to adjust the sensitivity enough so that it triggers the Warp on each shot.