Rikochet on a Warp?

[The Mag Man]

How can I do this? A hopper spacer is to big, and I can't get the right amount of electrical tape around the neck to get the perfect fit! Any ideas?

[rjvemt1]

open the warp housing and glue a strip of heavy grit sand paper into each side of the hopper reciever hole.

[The Mag Man]

I take it I wan't the grit facing out? And have you done this? Just asking, I wanna make sure it will work.

[rjvemt1]

yes, you want the grit facing out.i havent had to do this but i got the tip here. try searching 'sand paper' or try it without the glue first if your not sure. ive seen pics of the ric on a warp so i know it can be done.try a 3/8" wide 1/2" long strip on each side. i have an old vl 2000 that fits very snug, but the thread was about somebodys hopper falling out all the time so this might work for you.

[Matt Crawford]

I had to sand mine to fit in the warp......Just do the sand paper trick it should work.

[pito189]

Mine fit in there a little loose, then I tightened the screws down on the warp. No easy task as I am left hand and have the warp set up on the right. Anyways after I tightened it down it fits fine.

Crawford you are your little guys did a hell of a job at the WHP 3 man.

[Matt Crawford]

well we had a hard time against amature players, but we never gave up...well untill the last game.lol