Emag troubles...

[Johnny Bravo]

When I pull the trigger with the safety on, the gun will fire as soon as I turn the safety off.
Also, it likes to sometimes get "hung up" in E mode. Meaning it wont fire. I can quickly fix this by firing once in manual, but its a problem I'd much rather not have.

Are these two problems related by any chance? What can I do to fix it? Any help would be much appreciated.

[a_malfunction]

I would say that your trigger magnet is adjusted too close to the sensor.

[Havoc_online]

have your checked your solenoid plunger rod to make sure it's not getting hung up?

[Johnny Bravo]

Its not the magnet cause the solenoid still clicks, it just wont fire.

Havoc: How can I tell if my plunger rod is getting hung up?

[Havoc_online]

I dont know if that could be the problem, but just make sure that it's straight and doesnt have too much wear, you can also measure it to make sure it's the right length (3.005" ??)

[psifry]

trigger problems

did you screw around with the trigger magnet? I did the other day and it wouldn't fire the solenoid depending on how I squeezed the trigger (there is sideways slop in the trigger and unless I was pulling it back perfectly straight, then it wouldn't fire.
When I put it to Manual and then back to Electronic it would do what you mentioned.)

Back the trigger magnet out a bit and see if it fixes it.

let us know if what fixes the problem.

doug
Emag upgrade

[BetaMax]

I use to have this problem in my E-Mag, I realized it was my safety pin moving in the way trigger, meaning it was almost looking like it was freely moving in and out of safety. I removed my safety and never had that issue again.

Also, I would make sure your battery is fully charged. Charge it overnight before teh day of play.

This may apply to you or not.. May be worth looking