power feed to warp feed body

[K-villeplayer]

I have a power feed body. Hopper Right and I was wondering if anyone knew the measurments for where to cut to make it into a warp left body. If anyone has any info, it would be greatly appreciated.

Thanks

[than205]

I believe the correct thing to do is measure distance from the bottom of the powerfeed tube to the bottom of the window (cutout)in the powerfeed tube. And match that on the top side of the window. What you are trying to do is duplicate the proper placement of the feed plug on the top versus normally having it in the bottom. Do you follow my thinking?

[K-villeplayer]

Yes, I follow your thinking. I had not thought of it like that but it does make good sense. Thanks

[rjvemt1]

didn your warp come with the long parabolic plug that fits that body?

[K-villeplayer]

I have not ordered a warp yet, I just didn't want the parabolic elbow sticking wy up in the air. I thought if I cut it down, I could make it into a warp left body. That would be a tighter set up too.