My carrier wont fit down my ReTro power tube at all. I can install it in any 5 of my other stock valves and it works fine. Also is anyone working on the Hyper-Frame problem? I don't needs the response that if AG don't make it, shouldn't go on your gun. If that is the case then Tom should be proud the he has created his own Dinosaur.
-
"PLAY HARD OR GO HOME!"
IN MY BAG OF TRIX!- Black and Red ULE Hyped up ReTro MAG
- Black ULE Hyped up ReTro MAG
- Polished & Red Benchy LVL 10 MAG
- Polished & Blue Benchy MAG
- PF MAG wit Benchy frame
-
Try pushing it down with the cap of a ball point pen and make sure you havnt left anything in the PT.
-
Not even close to fitten. Tried and tried some more, no go. The power tube is to small."PLAY HARD OR GO HOME!"
IN MY BAG OF TRIX!- Black and Red ULE Hyped up ReTro MAG
- Black ULE Hyped up ReTro MAG
- Polished & Red Benchy LVL 10 MAG
- Polished & Blue Benchy MAG
- PF MAG wit Benchy frame
Comment
-
get it as far down as you can, then hand tighten the tip on to push it down (dont do this with the shims in there, they will bend) then once it's pushed down, take off the tip, put the shims in(making sure they are flat) and put the tip back on.....hope this helps.....Comment
Comment