Inteliframe - Safety not working.. Sear rod?

[dawump]

Hi guys,

Firstly.. the inteliframe? Awesome. Looks great, feels great and arrived ahead of schedule ;-)

My safety isn't working though, and I think that the sear rod ( correct terminology? ) is too long. When gassed up the tip of this rod is already touching the trigger. When the trigger is pulled with the safety on there is an "almost fired" sound with gas then escaping down the barrel.

If I do need to adjust my sear rod, what is the correct length for a level 7 mag? Also, can you be as exact as possible what the measurement is, eg tip of rod to pivot pin or tip to rod when at when at right angles to sear body.. you know what I mean.

I adjusted this way back when I was having trigger problems ( solved with a powertube spacer kit ) so it wouldn't suprise me if it is slightly out.

Thanks

Keith

[Remington]

I believe it's supposed to be 1.985" and I think its from the sear rod tip to the pivot point.

[Omicron]

[Cristobal]

Yeah, the trigger rod should not be touching the trigger at rest. When gassed up, but at rest, there should be a gap of about 1/16 inch (~1.6mm) between the end of the rod and the trigger.