trigger is limp when i gas up

[EsPo]

when i gas up the gun, minimag, the trigger is limp, i do not hear any leaks.

[a_malfunction]

Turn the velocity up.

[EsPo]

no, the trigger rod or sear or whatever isnt even pushing the trigger forward.

[EsPo]

the velocity is high

[lillfroboy]

take it apart and make sure you put it in right (i did the same thing and wondering what the heel happend) Just take my word for it and try it

[Havoc_online]

have you changed anything on the gun recently? what had me stumped for like 5 minutes was the new screws I put on for my grips went in too far and stopped the sear from moving.....but I'm guessing that there is a 1% chance that happened so double check everything else like making sure the on/off pin is in the right away and not backwards....

[FrAuStY]

Are you holding the trigger when gasssing up? Try that... then once your air supply is completely turned/screwed in, release the trigger. It could be pushing the bolt forward enough to keep the sear from latching and the trigger from going forward. It's generally a rule of thumb to hold trigger while gassing up as then you can tell where leaks are if there are any. Other than that... make sure your on/off pin is clean. I know with mine after about 3000 rds...it begins to get dirty (oil...need to by some KC troublefree WOOT!) anyway..goodluck and keep us posted

[EsPo]

this is not my gun, it is my friends, and i think it is his cradle, because it doesnt seem like there is air in the hoses. if he undoes the quick disconnect while the gun is gassed up, it wont blow up or anything if there is air in the hoses rite?

[lillfroboy]

it will leak

[lillfroboy]

more like dump air than leak

[EsPo]

still nothing it is acting like it is not gassed up.

[halo13]

anybody see the movie Tommy Boy? The title of this thread reminded me of a quote in that movie... "your trigger is limp like your ****!" hahahahaha..... I'm done.