This little ball poped out from the trigger frame, it was right near the saftey lock, now my saftey lock wont lock. How do I fix this?
-
Here's how I did it. Make sure you have the spring and the ball.
-Remove the trigger frame from the rest of the marker.
-Push the safety towards the left side of the grip (L/R based upon when firing) until you see a hole in the frame. The hole in the grip-frame is for the spring and ball. I tilted the grip away from me so when I placed the ball in there it would not roll out the side.
-Place the spring in the hole first and then place the ball on top of it.
-Now use something to push the ball into the hole (I used a paperclip) through the hole in the top of the frame. Once you get the ball below the level of the hole you can slide the safety pin to the right.
-Now slowly pull the paperclip out and move the safety pin over to cover the ball and spring.
That's how I did it. I hope that helps you.
Rockin -
I lost the spring, so Ill have to order one.Comment
Comment