1BPS no matter how fast the trigger is pulled

[A 10Bando]

My EMAG shoots on 1 BPS no matter how fast I pull the trigger unless I unscrew thw trigger frame from the rail and lift the from end of the body upward. Then the gun shoots like it is suppose to do. I have tried almost everything but nothing has worked. Even tried putting a spacer between the body and the rail to give it the effect of the body being off a rail but that failed. I am all out of ideas. I am open to all ideas maybe I just over looked something.

[halo13]

have you screwed with the trigger magnet at all? It might be out of the HAL sensor's range.

[Coaster]

will it shoot faster than 1bps when you have it in mechanical mode?

[A 10Bando]

reply to suggestions

The magnet are not the problem because the gun will still only shoot 1 bps with it in mechanical mode. Everytime I pull the trigger the shot count goes up so I know the electronics are working. I even tried using my rt pro valve and it still did not work unless the body was unscrewed from the rail. Thanks for the input.

[Coaster]

check the input pressure on your gun. Look at the regseat..

[A 10Bando]

It is fixed

It is fixed. I ordered a new on/off pin and it works just fine. I guess my old one was bent or something and now it is working sweet. I can max the bps from the first shot.