ok i just bought a used warp feed, 12v x-board, powerfeed adaptor for $100. it works fine, kinda. the guy who had it before me ran a intella feed link to his shocker so he removed the sensor. i have a powerfeed mag so i need that sensor. any way. how to i go about putting a sensor back on, or am i screwd. need help fast.
-
-
Your best bet is to skip the sensor idea and go with an intellifeed. ie: AGD Intelliframe
Otherwise you will need to order the sensor and the contact springs. Then you will need a pop rivet gun to put the sensor back into the shell.Thanotos
http://www.factcheck.org -
i have two pop rivit guns. how hard would it be to put it back in.Comment
-
are you sure the guy didnt use the jumpers to 'turn the sensor off'? did you get the instruction sheet with the warp? the set of three jumpers on the right hand side of the board are the sensor jumpers. i dont have my sheet infront of me, but ill give you a short summary. one of them is for a positive ground sensor. one is for a negative ground sensor and the other is for the stock potentiometer sensor(i think this is the bottom one). i was just gettin my stuff ready for tommorow and have already put it away. i would pull the back off if this wernt the case. call agd tech theyll tell you.Comment
-
Thanotos
http://www.factcheck.orgComment
Comment