micromag rt problems

[Cerebrus]

I would have sent an e-mail to airgun designs but there site says that there e-mail is backed up.

About 2 years ago I bought a used micromag rt with the vert feed. I have never had it in good working order and when it did work it would chop more balls than it shot(this is not a overstatement like i said it never worked properly). After that I refused to buy anything without an eye. Now with the release of the lv10 mod I would like to take the mag out of the closet and get it fixed.

So here is my question. I know absolutely nothing about mags and was wondering if agd would install a lv10 for me if I asked them to when I sent my mag in for repair? Will agd work on micromags since they use a proteam body? And again since the micromag does use an aftermarket body will there be extra charges?

Thank you for your time
Cerebrus

[personman]

I dont think there would need to be changes.
Its pretty easy to install level 10, I think as long as you know what the parts were called and you followed the instructions you could do it.
You should probally call up AGD..

[Bad_Knees]

Install on Micromag RT

I have the same body....you should be able to do it yourself like personman said. Not to hard...just get some air for your tank and be patient. Once you get it going you'll love it again

[Telefragged]

Some of the o-rings may have dried up over time and hardedned, maybe dissasembling the valve according to BlackVGC's instructions in one of the stickies up top, and clean, lube, and inspect the O-rings for wear or damage. It wouldn't be a bad idea to have an RT Parts kit handy while undertaking this.