Help With My MAg!!!

[DirtRider]

i gassed up my mag to try and shoot it, and it did nothing when i pulled the trigger! its a 68 automag classic, i've got the macro running directly to my valve from the asa and gassed it up with my nitro tank. I had a mac dev gladiator reg hook up, and it wasn't working right, i took it off and gassed it up and nothing happend when i tried to shoot. plz help

[DirtRider]

any 1?

[Spudchucker]

did the gun cock when the air was put in?

[DirtRider]

yea, it cocked, there was hardly any pressure on the trigger, more than with no gas, but not much.

[DirtRider]

Any 1?

c'mon!

[mihanikos]

try turning up the velocity. sounds like it's too low

[Spudchucker]

yea, the velocity is too low, or your air pressure is

[DirtRider]

i've got 2500 psi in my tank, and when i try to turn up the velocity, it starts leaking out of the velocity adjuster. I've even tried it with the velocity all the way up. c'mon guys i gotta fix this

[speedyejl]

whats your tanks output

[athomas]

Howe old is the mag?
Have you checked the o-rings and assembly order of the on/off assembly?

[DirtRider]

i bet its 2-3 years old, i'll check the o-rings and stuff. i let it sit last night with the tank hooked up and it would let me shoot a ball, after that, when you pulled the trigger, you could just hear a light hiss from the gas.

[mike e]

try adjusting your trigger rod length, it sounds too short, like the sear will catch the trigger but the trigger doesnt have enough travel drop it. i would say lengthen the rod

[athomas]

Check the bolt spring and the sear assembly.

The bolt spring should extend past the end of the bolt. If it doesn't, it is short and may be causing the bolt to stick.

Check the sear assembly for excessive wear and if the pin is properly seasted in the slot in the body rail.

[DirtRider]

don't worry

don't worry about it, i took it to the local proshop and droped it off.

[PyRo]

You know that the screw on the back, you need to turn it in to up the velocity, and out to turn it down right? Other than that it sounds like a problem with your tank, or your reg.