level 10 problem..grr!

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Snewk
    Registered User
    • Feb 2002
    • 351
    #1

    level 10 problem..grr!

    I have the smallest carrier, 2 shims, longest spring in. When I de-gas the second gauge on the flatline says there is 400psi still left going out to the gun, and I can't disconnect the macroline for anything. Any ideas?

    **edit...I just pushed really really really hard on it and it vented that 400 psi out, any idea why that 400 is residing in the macroline/valve?**
    Last edited by Snewk; 08-14-2002, 05:00 PM.
    Good Traders: TheSneakyPengui,spacemanspiff, Load SM5, lilpaintballer, PaInTbALL zAcH, mxkop.
    Bad Traders: None yet!

    Paintball is just tag at 300fps!
    Tags: None
    • codeJockey
      Tall Man With Shiny Scalp
      • Mar 2002
      • 78
      #2
      Take a look around at the various lvl-10 posts. There are several that say that the increased pressure is due to the higher pressure that the new bolt needs to funtion. You should get some kind of in-line degasser to take care of this issue. I use a proconnect & it works great...

        Comment

        • The Creature
          Bunker Spaz
          • Jul 2002
          • 64
          #3
          The remaining pressure is just a side effect of the level 10 bolt.

          to get around it all i do is this

          remove tank

          unscrew valve body bolt

          slide valve out the back allowing the on/off pin to finish degassing by smashing into the body rail

          it won't cause any damage to the assembly, and it will degas your gun without a degasser.

          P.S. make sure you don't shoot yourself in the forehead like i did the first time i took apart my mag lol.
          If you do not have the level 10 bolt, then you had better be on back order status with AGD!

            Comment

            Previous template Next
            Working...