I own a 2000 68 automag powerfeeder that currently runs on co2. I have just purchased a 48cu nitro 3000 tank and want to know what else I need, excluding LVL10 Mod, to make it go. Thanks.
-
-
an asa.. lol jk nothing at all, might wanna replace some orings in the valve if u ran co2.. like pt oring..RT
Ace'd Emag (sold)
Xmag (sold) -
Nitro Changes
HI,
Your Mag will be ready to go. The Regulator Piston will be current and for HPA. Probably the only thing you might want to think about is a) run some oil through the valve to lube up those O rings or B) Change out the O rings.
Usually a good lube will work and make sure you keep the gun lube after each day of play. HPA has a tendancy to dry out O rings. That will cause problems. 3-5 drys a day should do the trick.
Later,
AlanPaintball cannot be that big. No one has really been able to sponsor a stock car or a race yet. (local people do not count in this case :))
My FeedbackComment
-
Dude, screw in an air tank and your set. Use it the same way you used Co2.
Comment
Comment