Whats wrong with my mag?

[DirtRider]

When i try to shoot it, it will fire a couple shots like it is supposed to, and then it just will barly shoot the ball 10 feet. after about 10-15 balls that go ten foot, it will fire a normal 1. i can't figure it out, i don't wanna take it to the shop, so plz help. I need help by about wensday, or i will just take it to the shop. (i will be there any way to pick up my intelliframe) but plz help!

[PyRo]

Reg seat? Piston/spring pack? Tank not outputing right, somthing blocking the air line? Trigger rod ajusted?

[DirtRider]

trigger rod

yea, i think thats what it is. A guy told me that i needed to adjust it, and i think it is wrong now. how long is it supposed to be?

[PyRo]

1.985in

[PyRo]

Let me ask you, if you hold your trigger all teh way forward with teh gun gassed up, does teh trigger rod push against it? There should be a gap between the trigger and the rod. If you pull the trigger slowley, it should fire before the trigger is all the way back.

[DirtRider]

how?

how should i measure it? with what? thanks

[PyRo]

To get it to 1.985 you need dial calipers.

[DirtRider]

where could i get my hands on a set of these?

[PyRo]

Sears, home depot etc should have them. As long as you have those 2 gaps in your trigger though it should work.

[PyRo]

Sears, home depot etc should have them. As long as you have those 2 gaps in your trigger though it should work.

[DirtRider]

thank you

does this sound like it could be the problem: my trigger rod was about a little less than a quarter of an inch short. Thank you for helping me out, i gotta get my tank gassed up and make sure i fixed it tommorrow.

[PyRo]

I'm not sure what your talking about, but do you have those 2 gaps?

[DirtRider]

2 gaps?

i don't know what you mean by 2 gaps, but i adjusted it to 1.985 with a pair of dial calpiers like you said and then i gassed it up and it worked! i think i do know which gaps, i know that when the gun is together, the rod isn't actually touching it if i'm not pulling the trigger. but, i fixed it and i'm giving you credit for telling me how to.

[razorback]

Is the 1st measurement the length of the pin? What is the 2nd measurement?

[PyRo]

What? The whole thing should be 1.985in... And Dirtrider should go smack whoever told him to ajust it.