level 10 keeps stickin and i need help

[RILEY]

I have a mag with a powerfeed body, retro valve , and a hyperframe and i resently put in my level 10 and installed as the directions from online told me to do.Then when i tried all the springs it came with and the gun wouldnt fire with any of them. So i put my original spring back on and the gun and it finally fired but the problem i have is that when i shoot it and then stop shooting usually the bolt will stick but the bolt never sticks when i am shooting rapidly and i always oil it before i play so if anyone has any ideas for me i am open to suggestions.
thxs alot joe

[Havoc_online]

did you turn up your velocity? Try the cut spring again, the gun wont fire, you will have to turn the velocity up untill it fires reliably.

[RILEY]

hey I already have my velocity shooting about 277-280 should i turn my velocity up some more.

[BlackVCG]

When you install one of the longer springs. You MUST turn up the velocity. Even if it's shooting 280fps with the stock spring, you'll need to turn it up to get it to shoot, but it will still be able to shoot at 280fps.

To fix your sticking problem, use a carrier that is one size larger than the one you're using right now and make sure to use the same o-ring. If it starts leaking, then try a different o-ring.

[Angel_Freak069]

Hey sometimes when mine does that i have to take it all apart and oil every o ring. in it or other wise i add one of the metal Rings i use three in my gun