ok i just gassed up my mag and its leaking down the barrel when i pull te trigger a little bit it leaks a little further and it stops and i oiled it and was out side shooting the oil through and i got a couple where it leaked sfter a shot... im gunna check my oring carrier but what else could it be?
-
"You have not converted a man because you have silenced him." -John Morley
-
yea change your carrier that should fix it.. and some oilRT
Ace'd Emag (sold)
Xmag (sold) -
i changed carrier oring i guesse my old one must of dried out or sumthing cause it works now... ya i oiled it too... thanks for the advice..."You have not converted a man because you have silenced him." -John Morley
Comment
-
Take a shim out.
If it leaks and pulling the trigger slightly (not enough to fire the gun) stops the leak then you have too many shims in.
manikeComment
-
well it stoped for now but im playing tonight so if it leaks then il take out a shim.... its funn cause iv had my lv 10 set up for like a month or 2 now and the problem started today"You have not converted a man because you have silenced him." -John Morley
Comment
-
Weird
Comment
-
well i played with it yesterday and it worked fine so it must have been the oring or sumthing..."You have not converted a man because you have silenced him." -John Morley
Comment
-
Actually the o-ring may have just broken in.., now you put a new o-ring in and its a possibility that leak will surface again. I would have recommended removing the o-ring from current carrier, pu tit in the next smallest carrier.. then re-installed everything. I had to do this with mine after about 500 rounds when I first got LVL10 going. If it starts leaking again, do what I said..I'm pretty sure it'll stop the leak.
Comment
-
Gotcha frausty
"You have not converted a man because you have silenced him." -John Morley
Comment
Comment