Hyperframe Minimag problem

[BlindPop95]

I just bought a used minimag with a hyperframe trigger frame on it. It has a problem though. When i shoot it, it shoots but then it starts leaking down the barrel. Sometimes the bolt sticks.

The only way i know how to stop it is to push the sear down away from the on/off pin through the safety hole. (the safety fell out)

I use Co2 and as far as i know everything beside the on/off pin and the trigger frame is stock.

[BajaBoy]

make sure everything is well oiled.. and maybe some new on off and pt o rings.. nice gun

[Polishpickles451]

it sounds like u need a shorter PT spacer.

[BlindPop95]

I tried oiling it up but it didn't help. so i just ordered a spacer kit hope it works.


Thanks

[SaS]

is there wear on the sear and bolt?

I read something about that in the warpig.com review of the hyperframe

if i remember correctly...
some of the older mags and mini mags weren't terribly exact with the depth of the hole for the on/off

with a mechanical trigger, you don't notice the difference

but with the hyperframe and the short stroke of the soleniod... problems occure

you need a longer on/off pin... if i remember correctly

call centerflag and see what they have... also, you might want to check out that review
www.warpig.com ... it's in the technical section under the marker reviews

[SaS]

Bill Mills was runing into that same problem... or at least what sounds like it

we installed a hyperframe onto a minimag for the review article

[SaS]

YEA, that's it

the sear isn't locking down the bolt... with the bolt free, it can leak down the powertube and out the barrel

if problems persist (but i really do think it's the length of the on/off pin)
-you might also want to check the powertube o-ring to make sure that it's not worn too
-mess around with the spacer combination(or a longer powertube spring if that's what you have)