Need some help! Emag only fires sporadically.

[modogg19]

I just purchased a new Emag and I am having problems and need some help. I shot it for the first time today. At first it shot fine for about 100-125 shots. Then it would not shoot anymore. I still had plenty of air in my tank. Then after about 5 minutes of not shooting, it started working again and I was able to shoot another 75-100 balls before it stopped again. It seems like the gun is not re-cocking. It will not fire in E or M mode. My warp feed still turns tough every time I pull the trigger. My inlet pressure into the Emag regulator is ~800-825psi. This should be adequate to re-cock the gun correct? Please reply with any advise. Thank you.

[EnW]

Have you charged the battery?
You said it wouldn't fire in M...is that with the yellow pin in or out?

[modogg19]

The battery is charged and the pin is out.

[EnW]

You said new...new to you or brand new?
Mine did what you are saying and it needed a new battery.Mine was wore out!

Will it fire in manual mode? Pin in a switched to M.

[modogg19]

it is brand new, and will not fire in any mode. the rod that the trigger activates in manual mode is not returning to the correct position, therefore the trigger doesn't hit it. That's why I think the gun is not re-cocking. When it was firing that rod was in the correct position.

[EnW]

You have to put plenty of oil through it.

[BlackVCG]

You're getting bolt stick. Test fire the gun and get it to lock up. Then stick a squeggee down the end of the barrel and push it against the bolt if it recocks and you can start shooting again, then degas the gun and take the valve out. Unscrew the PT tip and look at the PT spacer that's in the gun. You need to replace it with one that's one size bigger than the current one. I'm assuming this E-Mag doesn't have LVL 10.