intell a revvy

[sniper88]

i have tried to open the files @ airgun.com but the program that opens pdf files if scrwed up on my comp. ok the question, what wires do i cut & reattach to the switch? i have taken the hopper apart down to the motor guts so i dont have a problem takeing it apart. any help would be nice.

[sniper88]

oh come on, someone has to know something.

[Spray Painter]

use search. i'm almost positve there will be something about how to set it up on AO

[sniper88]

i just did another search & found nothing. if some1 could open the file & run threw it & look @ the wires it would help alot.

[sniper88]

is it because i dont own a mag or own a ghillie suit??

[Schnitzel]

make sure you remove the plug from the board, and tap the white wire from the male end into the RED wire. Then attach the shielded end of the other wire either onto the volt regulator, or the battery teminal opposite the switch when looking at the termianls.

hope that helps.

[sniper88]

which with wire, 1 coming from sensor or coming from the board? & the part about the termianls i dont get.