Warp Feed Interface

[7lash]

Hey Guys,

I'm looking for info on how to interface to a Warp Feed. I'm assuming that I can use an open collector output in my circuit to pull the Warp Feed signal low but I cannot find any detailed info.

I've tried the AGD manuals and the FAQs, but now my eyes are tired and I need to sleep . Could someone please do me a huge favour and point me in the right direction.

Thanks in advance.

[hitech]

This is the wrong forum for this, however you can find the information in the manual under the Jumpers section.

You can either ground the pin or apply voltage. Then set the jumper accordingly. You can find the manual here:

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=97&CATID=15

[7lash]

Thanks

Apologies for posting in the wrong forum, and thanks for your help. Unfortunately, that manual does not give me the info that I need (current sink requirement).

Thanks again, I'll try elsewhere.