How hard will it be to swap level 10 mod from one valve to another?

[Thunderkiss]

The reason I am asking is because I am ordering a level 10 for my retro valve but I'll want to put it my AIR valve for a "No RT's touney" in November, and then swap it again afterwards. Will I run into any problems? Thanks

[Dayspring]

Should be as simple as pulling the LX stuff out and dropping it in the new valve. YOu're matching the Carrier/Oring to the Bolt, not the valve insides (correct me if I'm wrong). Should be very simple.

*EDIT*- Hello to a fellow Hoosier. Was born in Greenwood (S. Of Indy)

[Thunderkiss]

Hey thanks for clearing that up for me Dayspring. Always great to hear from fellow Hoosiers!

[cphilip]

Well partly but the shims and the springs may be sligtly different. But it's pretty darned easy to do. Do it like you did the first time but you know your already close on the carrier and such.

Moving to tech...

[PyRo]

Yeah, just go through the setup again on a differant valve.