Intelliframe ?
I've rigged my ricochet 2k w/ a virbating motor so it vibrates in my grip for a relaod alarm, not an audable alarm. In my stock minimag frame, right behind the trigger, and right below the sear, there was a cut out, with a hold drilled down through it, and that was a perfect fit for the motor i'm using, does any 1 know, or could some one be willing to take off the grips to their intelliframe, and tell me if that same notch, or a similar one is in there too? cause when i up grade, i would like to carry that little mod along w/ me. I know it's a long 1, but you're help would be usefull, cause if there isn't, it means i have to even more rigging.
-
AIM- TheJester493 IM me some time
take a look at my minimag
....
http://www.automags.org/forums/showt...threadid=64837 -
I'm not sure exactly what you're talking about since I've never a stock minimag frame. But, this could be helpful to you.
A bit into the instructions for the intellifeed, they show how to install it into the iframe, and they have pretty good pictures showing the iframe. Hope that helps.Don't think of it as being outnumbered, think of it as a wide target selection.
Comment