if i but my finger in my mag the bolt will just stop on it and it wont recock i can pull the trigger again and it will fire but i have the mid spring on it
-
good buyers/traders: becercom tunaman pullman richie CoFFeY[NiTrO]
www.vaporworks.net the best bushy upgrades!
www.infowars.com learn the truth about the goverment.
My Feedback -
A solution that comes to mind could be to swap the bolt spring out for the longest spring and re-adjust your settings for that one.
"The BEAST"
"No-Rise" E-mag
Level 10 Bolt
AGD Flatline 91cu in/4500psi
Black HALO B
"Red Heatseeker"
Red to Clear Fade Freak Factory Impulse
68/4500psi Max-Flo
Red HALO B
-
I think that's the way the level10 works.
As long as the bolt isn't venting air, I think it's fine. Mine recocks, but it might be different for the RT valve rather than a regular AIR valve.
If the bolt vents air when it stops on the finger, put one shim in at a time. Be careful though - if you didn't put the carrier in well, you could mangle a shim.Arnold Lee
Captain, USMA PaintballComment
-
you need to add a shim to bleed the pressure behind the bolt so it can re-engage. Most set-ups work best with two shims. I'd leave the cut spring.if i but my finger in my mag the bolt will just stop on it and it wont recockComment
Comment