How do i make the trigger pul shorter on my benchmark frame?

[GeNeRiCbRaNd]

How do i make the trigger pul shorter on my benchmark frame?I'ts a pretty long pull.

[markhauguel]

I had a BM frame on my mini when I bought it. It had a set screw tapped in from behind the trigger through the back of the grip frame and it limited the travel back. It seemed to work OK. I do not know what this did to the on/off but it made the travel about half what it was without the set screw. It always worked fine although you needed to push the trigger rod a little farther than the stop let it in order to get the valve out. So it must have not let the on/off press completely in. Don't change the trigger rod length because there needs to be clearance between the trigger and the rod so it kicks back and catches the bolt. I am not sure what the clearance needs to be but I know it needs to be there. I hope this helps it may not.

[SHAG]

Buy an Intelliframe

Hi,

Sell that benchmark and get an Intelliframe. I tried out one at NPPL Atlantic City and it was very nice. Also the AGD boys know what they are doing. i bought a 2 finger frame from BM and I was having all kinds of problems with the Retro valve. As it turned out the design of the benchmark frame was the culprit. It was the way BM designed the contact point of the trigger rod to the trigger. Tom stated AGD had said something to Benchmark about the problem and nothing was really done. so save your self soem problems and get the Intelliframe. It s on my Christmas list.

Later,
Alan