Intellifeed link

[alee@usma]

I'm not sure if this has been posted as a sticky elsewhere - I've been looking.

However, I want to link my warp feed up to my emag, and I imagine I could do it fairly easily, but I don't know which connector to hook it into, etc. I don't have the video, so I was wondering if anyone had written anything about this.

[DaosBeoulve]

a few things

http://www.robagd.com/

I know the emag/revvy power hack thing is on there. You can pick up the cable from the AGD online store to directly hook your emag into your warp. I know there's a web page somewhere showing all that in detail. Let me see if I can find it.

[Tunaman]

Plug it in the center connector...in the MIDDLE if the grip.

[Havoc_online]

I'm not sure if this has been posted as a sticky elsewhere - I've been looking.

taken from the sticky "all about the warpfeed"

quick reference on jumper settings for different set-ups.

with an Emag- place a jumper on the mid(pos.) pins (The connection runs into the center plug on the Emag board with a Emag/warp interface cable found at the Airgun online store)



in other words, the Tman is of course, correct.

[alee@usma]

wait a sec

I just looked inside the emag grip and the middle connector is already being used for the hall effect. There's one connector above it and one below it. which does the warp link go into?

[tjussery]

cable

This is the responce I got a while back.

http://www.automags.org/forums/showthread.php?s=&threadid=26292&highlight=warp+to+emag+link