warp feed questions

[Shadow221]

I just bought a used warp feed and I have some questions

When I got it it would spin constantly. I opened it up and saw that where you set it for positive negative and whatnot there was a jumper on all three. I'm going to be using the vibration sensor so I need the jumper on the bottom right? And I can also have one in the middle. I took out the top one and now it only spins when I turn the sensitivity up or press a small white bottom thats neer the little intellifeed port. I haven't tested it shooting because I have no air. When I shake the gun or hit it or something the warp doesn't spin though. Is this normal?

Well that's all I can think of. Anything else I should know?

[Havoc_online]

just wait till you have air to adjust the sensor. yes your jumper settings are correct.

[Shadow221]

ok. Thanks.

[Blazingace]

Check out the tech pages on Airguns.com They have instructions for setting the warp. There should be a blue knob in that panel that controls sensitivity. You should wait until you have air to set it like Havoc said.