Warp Feed set up questions.

[Potatoboy]

I just got some of the missing bits to my warp from AGD today and I have a few questions for all of you that have set one up.

I have an RTPro, Hopper Right Power Feed.

I Plan on running the warp into the short end of the power feed. The adapter that goes into the power feed seems a little loose on both ends (hose and power feed). How did you guys remedy this? I'm thinking Teflon or electrical tape.

The adapter from the warp to the hose is very loose. More electrical tape?

Also, for anyone that has a similar setup, is there enough room to run the hose between the forward grip and an intelliframe? I don't have my Iframe but it just shipped out today. If there isn't enough room how did you do it?

P.S. My warp feed hose is black. I've only seen gray around. Does this make me special?

[a_malfunction]

I fixed the slight bit of looseness with electrical tape. Oh, and my Warp came with a grey hose, but I cut it too short and had to order a new one. I got black as well. I like it better because the rest of my gun is black as well. It matches much better.

[DarkPhoenix]

Did you put the three o-rings on the hose before you inserted it into the adapter?

[Potatoboy]

O-rings?

[alf]

a_malfunction: me too (cut it too short)...mounted it to my benchy, then got a Z-grip...

darkphoenix: 3 o-rings? never heard of this one

potatoboy (i hereby dub thee TATER) (if thats alright...if not, i retract above dubbing)...my hose was loose too, but the length of the hose between the warp and the lower opening of the PF keep it pretty secure...are you going to have to cut your revvy? if you do, i have some pics of mine...so you can see...blackvcg also has some good pics of how he did his

[Potatoboy]

The dubbing is fine, that's my nickname for my nickname my friends gave me anyway. If I don't use some electrical tape it's going to pop out of the powerfeed because of the way i have it run, it's going under the gun and to the short side of the power feed.

[AGD]

If you have the black hose it should have come with orings in a little plastic bag with instructions on how to put them on. That will cure the problem.

AGD

[Potatoboy]

I have nothing of the sort. I got black hose, the upper adapther, and a long powerfeed plug. I need to use it this weekend, so i'll just use tape, it shouldn't hurt anything.