I've had my Emag LX since just prior to IAO. I gasses it up today(Flatline 4500) and there was a massive leak out the back hole. I have no idea what has caused it and it's been functioning fine for over 10 cases.
-
-
Did you take out the bolt to see if the piston pin is still in place? That's a two piece system, and it's been known for that piece to come out and fall into the dump chamber. That coming out would cause a massive leak. If that's the case, put a bit of red loctite on the end and then tap it in with a smooth face hammer. To make sure it's in all the way, measure from the tip of the bolt to the tip of the pin and it should be 2.010" -
I think AGD should be adding a new, higher rated regulator piston in the LX kits. I am seeing too much of this venting out the back holeComment
-
i had this happen about a week ago.... my LvX was installed sence the 1st batch of betas and working fine... i didnt play for a couple of weeks went to fire off some old paint in my back yard and soon as i turned the air on air came blasting out the back.... i shut the air off then back on once the air stoped coming out the back.... still leaked.... once it stoped again i put about 4 drops of oil in my q/d fitting gassed up again and fire off a bunch of shots and it has been fine ever sence.......
the one thing i am noticing is that with the LvX, one must keep the valve well oiled... meaning a drop or 2 before play and esp if not gassed up for a while... to kepp it running good.....other wise there is a leak somewhere..... sence then i have had no problems....Virus, King of the Basement Trollz has spoken
Comment
Comment