Rev off Emag Battery

[Oddball]

I know it is possible and was looking for how to do it. I did a search and only found one thread that talked about how to actually put it together but the link to the directions doesn't work. The link was to a page set up by RobAGD. Can anyone post a link or just post how to do it? Thanks.

[psifry]

huh?

I don't understand what you are trying to do. Can you elaborate on what you are attempting?

"rev the battery pack?"

ds

[DaosBeoulve]

http://www.robagd.com/

Under the warp/revvy hack part, I do believe. Good luck with it=)

[kutter]

OK, I have a question about this, have had it for some time in fact. I know that the Warp needs to be regulated down to 12 volts to not fry it, but what about the Revy? Does it need a regulator or will it run fine on the 18 volt input, since that is what the batteries give it in the first place?

[Coaster]

the batteries arn't necessarily giving it 18volts, although they might be. One way of wiring the batteries woudl give 18volts, the other with 9volts but twice as much amperage. Again, i am not sure how it is wired but it is one of those.

[Kevmag]

Does it need a regulator or will it run fine on the 18 volt input, since that is what the batteries give it in the first place?

The 12V Revy has a regulator that brings it down to 12V, so an external reg is not required.

[Oddball]

Thanks 4 the link

I am going to do it on Friday. I will post how it goes.

[davej946]

Originally posted by DaosBeoulve
http://www.robagd.com/

Under the warp/revvy hack part, I do believe. Good luck with it=)

Actually, it under the Emag & Revy Power Hack... noob

Just jokin'!

Later ~ Dave

[Oddball]

Its Done!

Well it took about 1 hour to do but I was watching a movie while doing it and had to figure a few things out to get it to work. First thing is that the ONLY permanent thing done to the gun or hopper was cutting a hole in the battery door for wires to go though. Only cost about $7 at Radio Shack. I used the setup today with no problems.

[Halliday]

I've read the RobAGD hack, but can't make heads or tails from the directions. Does anybody have instructions that I might find more clear?