micro emag leaking down the barrel bad

[dropkick1]

well i just got my micro emag back from AGD b/c the trigger magnet fell out and it worked flawlessy when i was dry firing it with the air i had left, but this morning i went to gas it up and good around with it and it just started leaking down the barrel bad.

i tried changeing the pt spacer bigger, but it didn't really do anything

i don't know what to do now, all the o-rings were just replaced by AGD and worked fine a couple of days ago, please help.

ken

[Tunaman]

It probably didnt air up properly. You need to give it a good blast of air to cock it. Mine does this also. Just put a squeegee down the barrel and push on the bolt .

[dropkick1]

thanx tunaman, i was thinking that at work but i didn't have a chance to do that before i had to go, i'll try that tommorow, once again, thanx for your help.

ken

[Havoc_online]

shorter spacers fix leaks. you should be fine but make sure the bumper and spring are good.

[misfit]

sorry, problem was fixed, all th o rings were just replaced as stated above, but the bolt was seating correctly. so i just pushed it back into place, and niow is fixed.

ken

[cphilip]

Yea but Havoc is right...leak down the barrel from spacer issue means go shorter. But in this case it does sound like failure to cock on first time only and that would be air up blast like Tuna said. If its only the first time you air up that is it. Try holding the trigger back while you screw in and then let it up. That can help...