AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
I cut my standard feed down by about half and havent ever had a problem. I think the length is for a good ball stack and feed with standard hoppers, if you run a Revy or Halo you wont have a problem.
would it be a good idea to cut .7 of an inch off since that is the lenth of one ball? That would be just one less ball on the stack correct? If i was going to cut mine i would cut .7 off with a pipe cutter.
Comment