foamy or no foamy?

[Berner9]

i was shooting air and the foamy from my lvl 10 went flying out. so i stuck my finger in there and it still seemed to work. but i wonder weather i should put my new one in or not? will in make a difference?

thanks

[Load SM5]

It'll work but it's better to have the foamie in there.

[Berner9]

well alright, but how do you get the foamy to stick to the bolt?

[Tunaman]

clean all the old glue off the bolt. Then scratch the surface of the bolt real good. Use some good epoxy and let it dry for 24 hrs.

[Zenwood]

Originally posted by Tunaman
clean all the old glue off the bolt. Then scratch the surface of the bolt real good. Use some good epoxy and let it dry for 24 hrs.

Specifically what kind of epoxy do you use Tunaman ? There are a lot of different grades and some of them might be a little too strong and hard to remove. My first foamie on my lvl 10 is still hangin in there but when it eventually goes I was just going to use krazy glue for the next one(sufficient?). I have clear 2-ton epoxy but I have second thought about using that.

I wonder what AGD uses for the one that comes with the bolt ? That seems to be doing a good job so far. Mods ?

[Skeetmaster]

I thought AGD had moved away from foamies, with the foami-less bolts "long nose". I take it these wont work with the LX?
So I still have to worrie about foamies when I get LX, DOH!
In England, we have Araldite. That ought to stick em on, if not Super glue.
Gaz