New RT on Minimag no trigger pull

[projekt23]

I just received my retro valve today and promtley installed into my minimag. When I gas up I can feel the presure on the trigger but cannot fire. I can pull the trigger back but still nothing, the guy at my local shop thinks that it is not catching but was unable (in the 10 minutes before closing) to determine what the problem is.

I had my LX kit working on the standard valve and throw that into the RT Valve to eliminate a few possiblities. with the LX kit in I am still getting the same response??

Minimag/RT/LX/Intelli/PMI 68 4500

Thanks again for your help.. this boards patrons are killer!


- also this valve came out of minimag sent to my girl friend since her brother got a bushmaster so I am sure I need a parts kit (side note) would this cause this though?

[Coaster]

look at all the suggestions in this thread, this guy seemed to have similar problems. http://www.automags.org/forums/showt...threadid=52432

[a_malfunction]

It might have been said in the link that coaster mentioned, but Try turning the velocity up. See if you can get it to fire before it starts venting the excess pressure.

[projekt23]

I had the marker turned up all teh way and it is still reacting the same... There are no parts kits here in Az for the RT so I am now hoping that my local tech has a few of the really little Orings and maybe the swelling is causing the marker not to fire... I dunno - Thanks for your suggestions though

[projekt23]

HAHA, so the problem was my Sear... It work on the intelli with the old valve not the retro, a new sear and I was up and running.. thanks to all of you that offered to go out of your way to help me out.. this community is the Sh#t

[Tunaman]

I think he means the new trigger rod ajustment that COMES with a new sear...