Automag Help (bolt sticks, ball breakage and large bursts of CO2)

[Kanuck]

I have recently purchased a Lvl 7 automag and used it for the first time today. The Mag is equiped with an ANS bolt and PMI expansion chamber. I am running it off of CO2(not anti-siphon) and noticed that after approximately ten shots, the marker began to fire large bursts of CO2. This resulted in ball breakage as well as the bolt sticking. I usually had to play with the trigger so the bolt would return. Does anyone know what could be causing this? The marker has all new seals and its clean inside and out. Could it be that today was a fairly cold day? Does the velocity need adjusting? I am really not very familiar with Mags and any advice would be greatly appreciated.

Thanks

[TNS2k2]

GET AN ANTI-SYPHON!!
that is prolly your problem. you need that, especially with a mag and with cold weather.

[joeyjoe367]

save yourself a ton of trouble and get yourself a n2 system, if it's available in your area.

Trust me, once you go n2, you'll never look back.

[Nobody077]

You Need anti-siphon put in your tank, Mags dont like liquid and if it was a cold day you probaly were getting a little liquid. Allso since you got the mag used I would suggest geting a repair kit from the online AGD store(link at top of forum page) and replace the o-rings and Bolt spring, the kit is $20. If you dident get the manual for the mag call AGD and I think they will send you one for the cost of shipping. Good Luck